Arrival times from intermediate-depth (110--150 km) earthquakes within the region of flat subduction beneath the subandean zone and foreland basins of east-central Peru provide constraints on the geometry and velocity structure of the subducting Nazca plate. Hypocentral locations and origin times for these events were determined using observations from a 15 station digitally recording locator array deployed in the epicentral region of eastern Peru. Observed P wave arrival times for coastal stations in Peru, some 3--6¿ from the epicenters, are up to 4 s early relative to predicted arrival times based on the best fit velocity-depth model used for hypocenter locations. These large negative time residuals appear to be the result of propagation paths which have long segments in the colder, higher-velocity subducting plate. P wave travel times were modeled for the effects of the slab using three-dimensional (3-D) ray tracing. Computed ray paths show that travel times to coastal stations for the eastern Peru events can be satisfactorily modeled with average velocities relative to the surrounding mantle 6% lower within the uppermost slab (assumed on the basis of other studies to be unconverted basaltic oceanic crust 6 km thick) and 8% higher within the cold uppermost mantle of the slab.

Ray tracing for this plate model shows that P wave ''shadow zones'' can occur if the source-slab-receiver geometry results in seismic rays passing through regions in which the dip angle of the slab changes significantly. Such geometries exist for seismic waves propagating to some coastal stations from intermediate-depth earthquakes located east of the Andes. Observed first-arrival times for such cases do in fact have smaller negative residuals than those for geometries which allow for ''direct'' paths at similar distances. Modeling such arrivals as internally reflected waves propagating through the high-velocity part of the plate produces a significant improvement in the travel time residuals. For the slab velocities given above, we obtain a model thickness of approximately 36 km for the cold slab interior and a slight northwest component of dip in the region of subhorizontal subduction.